Driver — bit slips in the screw
Match the bit profile and condition with the tool disconnected. Do not use extra force to overcome a mismatch.
Difficulty
Easy
Time
5–25 min
Cost
—
Symptoms
- bit slips out of the screw head
- bit does not fit the screw
Possible causes
1Incorrect bit profile
Less likelyThis is a possible explanation, not a confirmed diagnosis. Compare it with the safe checks below.
- With the tool disconnected, match bit markings to the screw recess. PH, PZ and Torx are not interchangeable.
2Worn tip
Less likelyThis is a possible explanation, not a confirmed diagnosis. Compare it with the safe checks below.
- Fit a sound bit using the holder instructions. Do not run the tool while holding the bit with your fingers.
3Damaged screw recess
Less likelyThis is a possible explanation, not a confirmed diagnosis. Compare it with the safe checks below.
- Set the correct mode and clutch as instructed. Secure the workpiece and wear eye protection; do not test on electrical or gas installations.
Initial checks
- With the tool disconnected, match bit markings to the screw recess. PH, PZ and Torx are not interchangeable.
- Fit a sound bit using the holder instructions. Do not run the tool while holding the bit with your fingers.
- Set the correct mode and clutch as instructed. Secure the workpiece and wear eye protection; do not test on electrical or gas installations.
Step-by-step repair instructions
- 1
Prepare a safe place

Conceptual illustration. Follow the text and your model's manual. Switch off the tool and unplug it or remove its battery as instructed. Keep away from blades. Work only on parts identified as user-serviceable.
Expected result: You understand the model instructions and can safely perform the listed tasks.
About 3 min
Stop if: The model, access or safe preparation is unclear.
- 2
Compare the profile

Conceptual illustration. Follow the text and your model's manual. With the tool disconnected, match bit markings to the screw recess. PH, PZ and Torx are not interchangeable.
Expected result: The bit matches the profile and size.
About 4 min
Stop if: The profile is unclear or the recess is damaged.
- 3
Check bit retention

Conceptual illustration. Follow the text and your model's manual. Fit a sound bit using the holder instructions. Do not run the tool while holding the bit with your fingers.
Expected result: The bit is correctly retained.
About 4 min
Stop if: The holder does not retain the bit.
- 4
Choose the mode

Conceptual illustration. Follow the text and your model's manual. Set the correct mode and clutch as instructed. Secure the workpiece and wear eye protection; do not test on electrical or gas installations.
Expected result: The bit stays engaged during a brief controlled trial.
About 4 min
Stop if: The screw jams or excessive force is needed.
- 5
Check the outcome and save your notes

Conceptual illustration. Follow the text and your model's manual. Restore parts to their normal position as instructed. Perform one brief, safe check. Note what changed after each task; if the fault remains, give a technician the model and a photo of the symptom.
Expected result: The symptom has stopped or you have clear notes for a technician.
About 3 min
Stop if: A damaged holder or a screw in a safety-critical part requires a professional solution.
When should you call a professional?
A damaged holder or a screw in a safety-critical part requires a professional solution.
Does your situation look different?
Take a photo — FIXIT will assess your fault and suggest checks for your situation.
Check your problemThis guide is for information only. If unsure, get professional help. In an emergency, call 112.