Motorcycle clothing — hook-and-loop closure will not hold
Remove lint and assess the fastening without altering protection.
Difficulty
Easy
Time
5–25 min
Cost
—
Symptoms
- cuff or flap opens by itself
Possible causes
1Lint clogs the fastening
Less likelyThis is a possible explanation, not a confirmed diagnosis. Compare it with the safe checks below.
- Take the garment off and lay it flat. Inspect both fastening surfaces, seams and protector pockets. Do not cut stitching.
Initial checks
- Take the garment off and lay it flat. Inspect both fastening surfaces, seams and protector pockets. Do not cut stitching.
- Remove loose fibres by hand or with a soft brush as permitted. Do not use flame or solvent.
- Fasten the full overlap on the unworn garment. Check gently that it holds and the protector stays in place.
Step-by-step repair instructions
- 1
Prepare a safe place

Reference diagram. The marker shows an example inspection area. Follow your model's manual. 
Conceptual illustration. Follow the text and your model's manual. Place the motorcycle securely on level ground, stop the engine and put the key aside. Do not work in traffic or near hot parts.
Expected result: You understand the model instructions and can safely perform the listed tasks.
About 3 min
Stop if: The model, access or safe preparation is unclear.
- 2
Inspect the damage

Reference diagram. The marker shows an example inspection area. Follow your model's manual. 
Conceptual illustration. Follow the text and your model's manual. Take the garment off and lay it flat. Inspect both fastening surfaces, seams and protector pockets. Do not cut stitching.
Expected result: You identify dirt or wear.
About 4 min
Stop if: Protective stitching is torn.
- 3
Remove lint

Reference diagram. The marker shows an example inspection area. Follow your model's manual. 
Conceptual illustration. Follow the text and your model's manual. Remove loose fibres by hand or with a soft brush as permitted. Do not use flame or solvent.
Expected result: Hooks are free of lint.
About 4 min
Stop if: The material frays under light contact.
- 4
Close the full overlap

Reference diagram. The marker shows an example inspection area. Follow your model's manual. 
Conceptual illustration. Follow the text and your model's manual. Fasten the full overlap on the unworn garment. Check gently that it holds and the protector stays in place.
Expected result: The closure stays fastened.
About 4 min
Stop if: The flap opens or a protector shifts.
- 5
Check the outcome and save your notes

Reference diagram. The marker shows an example inspection area. Follow your model's manual. 
Conceptual illustration. Follow the text and your model's manual. Restore parts to their normal position as instructed. Perform one brief, safe check. Note what changed after each task; if the fault remains, give a technician the model and a photo of the symptom.
Expected result: The symptom has stopped or you have clear notes for a technician.
About 3 min
Stop if: Use a manufacturer-approved repair for a worn protective-garment closure. Do not substitute a safety pin.
When should you call a professional?
Use a manufacturer-approved repair for a worn protective-garment closure. Do not substitute a safety pin.
Does your situation look different?
Take a photo — FIXIT will assess your fault and suggest checks for your situation.
Check your problemThis guide is for information only. If unsure, get professional help. In an emergency, call 112.